MAINTENANCE CHEMICALS
www.ship-service.ru

AMEROID OWS - Quick Separating Degreaser

Description

AMEROID OWS quick separating degreaser is a superior solvent emulsifying detergent for general engine room degreasing and for cleaning and gas freeing of bilges. Its unique blend of surfactants, wetting agents, and solvents results in a product, which has exceptional cleaning properties, breaks quickly, and does not harm the operation of oily water separators required under the MARPOL regulations.

AMEROID OWS quick separating degreaser has been thoroughly tested and is approved by the following separating and bilge alarm manufacturers.

• Biospherics Incorporated

• Blohm & Voss AG

• Butterworth Systems (UK) Ltd.

• Hamworthy Engineering Ltd.

• Hodge Separators Limited

• Italgestra S.P.A.

• National Fluid Separators, Inc.

• Nelson Division, Nelson Industries

• Quantek, Inc. (Facet Enterprises)

• SEREP

• Separation and Recovery Systems, Inc.

• Sigma Treatment Systems

• World Water Systems, Inc.

• Approved for use onboard U.S. Coast Guard vessels

Application

Typical cleaning solution strength will vary from 0.1% - 10% depending upon the type soil and the method of cleaning. AMEROID OWS degreaser may be diluted with fresh or seawater depending upon the cleaning required. If the spent cleaning solution is to go through an oily water separator, ensure that the concentration does not exceed recommended levels set by the separator manufacturer. The level which is recommended by those manufacturers testing and recommending AMEROID OWS degreaser is generally 0.1%. If possible, allow time for settling and separation of waste water and oil to occur. This will enhance separator operation.

General Degreasing

For general purpose cleaning and degreasing, use AMEROID OWS quick separating degreaser neat or diluted to a 5% concentration depending on the type soil to be cleaned. Apply the cleaning solution by brushing or swabbing, allow the solution to penetrate the soil, then rinse with warm water, 40° - 60° C (100° - 140° F). When using mechanical spray units, AMEROID OWS degreaser may be used in concentrations as low as 0.1% depending upon conditions.

Bilge Cleaning

To clean oil from bilges by the rock-and-roll method, add AMEROID OWS degreaser at one or more locations in the bilge at the approximate dosage level indicated in the table below. Add seawater to fill approximately 1/3 of the bilge capacity to form a 0.1% cleaning solution. Allow the natural rock-and-roll motion of the vessel to provide agitation for a minimum of 24 hours. At the end of 24 hours, pump the bilge in accordance with normal procedures, inspect; and if required, repeat the procedure or spot clean.

NOTE: AMEROID® OWS quick separating degreaser should be diluted to 0.1% by volume prior to being passed through a separator. This is the concentrate generally recommended by most separator manufacturers. Use of traditional type emulsifying cleaners with AMEROID OWS degreaser will affect its quick-breaking characteristics and should be avoided.

Typical Physical Properties

Appearance: Clear, light amber

Specific Gravity at 25° C (77° F): 0.88

Flash Point (PMCC): 65° C (149° F) min.

Packaging

AMEROID OWS quick separating degreaser is available in 25-liter containers.

Important Information

Ashland maintains Material Safety Data Sheets on all of its products. Material Safety Data Sheets contain health and safety information for your development of appropriate product handling procedures to protect your employees and customers.

Our Material Safety Data Sheets should be read and understood by all of your supervisory personnel and employees before using Ashland products in your facilities.